INSTALLATION:

Proper installation is crucial to ensure a tight permanent hold and long term value for your truck. Please follow the following steps closely to ensure your Full Front Bed or Bulkhead Protector installs properly and looks great for years to come!

1. Thoroughly wash your truck's front bed or bulkhead area with soap and water. Make sure your bulkhead area is completely clean.


2. Rinse and wipe down with a dry cloth. Let dry.


3. Thoroughly clean your truck's front bed or bulkhead surface with the enclosed alcohol wipes. This will ensure the alignment strips adhere properly.


4. Carefully test fit the METAL MONSTER USA Full Front Bed or Bulkhead Protector BEFORE removing any of the backing on the 3M tape alignment strips. Set the Full Front Bed or Bulkhead Protector on lightly and check alignment and fit.


5. Make sure the fit is correct for your truck. If you have any concerns, please contact the TRUCKED UP™ Customer Experience Team!


6. Take the Full Front Bed or Bulkhead Protector back off your truck and remove the backing from the 3M alignment strips.


7. Hold the Full Front Bed or Bulkhead Protector back over your truck's bulkhead surface and settle it down in the same location and alignment you used for your test fit.


8. Press your new Full Front Bed or Bulkhead Protector down firmly down its full length.


9. Use a power drill to install each of the included self-tapping stainless steel screws to affix your Full Front Bed or Bulkhead Protector permanently to your truck.